1) What Is Hygrometer?

The eyelash extension glue hardens immediately in response to a small amount of moisture in the air. On the surface, you apply to the most suitable curing time can be obtained when the humidity is between 45% – 55%. Any number below 45% is count as low humidity, and any number above 55% as high humidity. High humid make the curing process faster.

2) Does humidity affect eyelash extensions?

All eyelash extension glues contain cyanoacrylate. Cyanoacrylate reacts strongly to humidity – or the lack of it: – In case of too high humidity level in the air, the cyanoacrylate in the glue dries too fast, causing curing shock or crystallization.

3) What should the humidity be for lash extensions?

When applying for eyelash extensions, your room temperature should be between 16 and 24°C, and your humidity should be between 40 and 70%. To monitor your humidity levels, we recommend using a hygrometer that measures the humidity and moisture in your treatment room.

4) How do you use a hygrometer?

It uses a pair of thermometers standing side by side. One has a bulb open to the air; the other has a bulb covered in a wet cloth. The water on the cloth causes evaporation and heat loss from the bulb, making the reading lower than that on the dry-bulb thermometer.

5) How do you treat eyelash extensions?

  1. Wait 2 minutes after finishing your lash application to avoid shock polymerization.
  2. Squeeze one small drop of Glue Instant Cure onto a microfiber brush
  3. Wipe over bonding points from the top and then from the bottom (by lifting lashes). You do not need to soak bonding points.
  4. Wait until dry and brush lashes to fluff them up.
  5. 3 minutes after Instant Cure has dried, the client can wash their lashes (this is recommended to eliminate any vapours that have fallen around the eyes during the treatment). You do not need to use Nano mister/Nebuliser as Glue Instant Cure finalized the treatment for you!

6) How do I know if my hygrometer is accurate?

  1. Gather supplies. To test your hygrometer using salt, you need a few household supplies. …
  2. Fill the cap with salt and add enough water to make a thick slurry. …
  3. Put the cap and the hygrometer inside the baggie. …
  4. Wait 6 hours. …
  5. Read the hygrometer. …
  6. Adjust the hygrometer if necessary.

7) How do you check humidity without a hygrometer?

Usually, you can measure this with a hygrometer, a simple meter that tells you what percentage of water vapour the air contains. However, if you don’t have a hygrometer or want to figure out the humidity without one, there are other ways. The simplest way is to use wet- and dry-bulb temperatures.

8) Do you need to calibrate a hygrometer?

It would help if you calibrated Hygrometers yearly. Hygrometers are available in both digital and dial models and should check both for calibration. Some dial types will have a small screw or adjustment on the back so you can adjust them after calibration.

Love You All


Leave a Comment